Diesel Repair Glossary

Clear definitions for the terms you’ll find in The Roadside Report and hear during a service call.

Aftertreatment

Equipment in a diesel engine's exhaust system that reduces pollutants after combustion. Depending on the engine, it can include filters, catalysts and a DEF dosing system.

An aftertreatment warning describes an emissions-system concern; it does not identify a failed part by itself.

Reference: Cummins: How an aftertreatment system works

Battery

An electrical energy storage device that supplies power for starting the engine and for electrical equipment. A truck may use several batteries together.

Slow cranking can justify a battery and starting-system assessment, but it does not prove the battery needs replacement.

Coolant

The specified fluid circulated through an engine's cooling system to carry away heat and help protect against freezing and corrosion.

Use the coolant type and service procedure required by the engine manufacturer. Different products are not automatically interchangeable.

Cranking

The starter turning the engine during an attempt to start it. An engine can crank without starting and running on its own.

Tell dispatch whether the engine turns at its usual speed, turns slowly or does not turn at all.

DEF (Diesel Exhaust Fluid)

A water-and-urea solution used by selective catalytic reduction systems to reduce nitrogen oxides in diesel exhaust. DEF goes in its own tank, not in the diesel fuel tank.

Follow the manufacturer's handling instructions. DEF is an emissions fluid, not a diesel fuel additive.

Reference: Cummins: How an aftertreatment system works

Derate

A reduction in the engine's available power or operating limits. An electronic control system may impose a derate in response to a fault or operating condition.

A derate is a condition to investigate, not a diagnosis. Record the exact dashboard messages and follow the engine manufacturer's instructions.

Diagnostics

The process of using reported symptoms, inspections, measurements and diagnostic tools to identify the cause of a problem.

Reading a fault code is one diagnostic step. It does not automatically establish which component should be replaced.

Engine Heater

A manufacturer-approved device used to warm part of an engine before starting in cold conditions. The design and power requirements depend on the truck and engine.

Review the truck's instructions before connecting or operating a heater. Do not assume every truck uses the same equipment.

Fault Code

An identifier recorded or displayed by a vehicle's electronic control system when it detects a condition outside its expected range.

Save the code exactly as shown, together with the dashboard message and symptoms. A code is a starting point for diagnosis.

Mobile Diesel Repair

Diesel diagnostic or repair work performed by a technician who travels to the vehicle's location, such as a yard, job site, truck stop or suitable roadside location.

The fault, available parts and safe access determine what can be repaired on site. Some trucks still require recovery or a shop visit.

No Crank

A starting symptom in which the engine does not turn over when a start is requested.

Distinguish this from an engine that turns normally but will not start. Report any clicks, warning messages or other observations.

No-Start

A general description of an engine that will not start. It may involve no cranking, slow cranking, or normal cranking without the engine beginning to run.

Describe the behavior rather than only saying the truck will not start. The different symptoms guide different checks.

Slow Crank

A starting symptom in which the starter turns the engine more slowly than its normal starting speed.

Several starting or electrical conditions can cause slow cranking. A battery test alone may not explain the whole problem.

Starter

The motor and associated drive mechanism that turn an engine during starting, before the engine can run under its own power.

A starting complaint does not by itself prove the starter has failed; power supply and control issues also need consideration.

Starting System

The components and controls involved in turning the engine during a start request, including batteries, cables, the starter and its control circuit.

A starting-system assessment considers the system together rather than replacing a component based only on a symptom.

Stop-Engine Warning

A critical dashboard warning directing the operator to follow the manufacturer's stopping or shutdown instructions for a detected condition.

Record the exact message and follow the truck's manual. A general online explanation is not permission to keep driving.

Traction Devices

Equipment, such as approved tire chains, used to improve tire grip in winter conditions. Acceptable equipment and installation depend on the vehicle and active road requirements.

Check current requirements for your route; this definition does not specify which equipment satisfies a particular restriction.

Reference: UDOT: Commercial vehicle snow tire and chain requirements

Warning Devices

Equipment used to alert approaching traffic to a stopped vehicle, such as reflective warning triangles. Requirements and placement depend on the roadway and circumstances.

Follow carrier procedures and the applicable rules. This definition is not a complete placement guide.

Reference: FMCSA: Stopped commercial motor vehicles