← The Roadside Report

Roadside Advice

Semi Truck Breakdown on I-70 or I-15 in Utah: What to Tell Dispatch

By Interstate Roadside Services ·

When a semi truck loses power or will not restart, the first service call should establish two things: where the truck is and what is happening. A clear handoff helps dispatch assess the situation and discuss the next step. This guide is for drivers using I-70 and I-15 through central and southern Utah, including the Richfield, Fillmore and Beaver areas.

Address an immediate hazard first

If there is a collision, fire, injury or an immediate traffic danger, call 911. Follow your training, carrier procedures and instructions from emergency personnel. Do not try to inspect a truck from an exposed position beside moving traffic.

FMCSA's guidance for a commercial vehicle stopped on a highway or shoulder addresses hazard lights and warning-device placement, including a general requirement to place warning devices within 10 minutes. Placement varies with the roadway and circumstances. Review the official guidance and your carrier's procedures; this article is not a complete warning-device placement guide.

Sources: FMCSA Motor Carrier Safety Planner: Stopped commercial motor vehicles

Give a location that identifies your side of the road

Start with the highway number and direction of travel. Add the nearest exit, mile marker or town. On a divided highway, a location without a direction can leave a service provider planning for the wrong approach.

If the truck is at a truck stop, yard or job site, give the entrance, parking area and any access instructions. A location pin can help, but say whether you are on the roadway, shoulder, ramp or inside a property. Tell dispatch if the truck is obstructing traffic or cannot be approached safely.

  • Highway and direction: for example, I-15 northbound.
  • Nearest exit or mile marker, plus a location pin if available.
  • Truck position and any immediate access or traffic concerns.
  • A callback number and your fleet's dispatch contact.

Describe the symptom before naming a failed part

Say whether the engine cranks, starts and stops, runs with reduced power, or does not respond at all. Read dashboard messages accurately, and save a photo or the displayed fault codes when it is safe to do so. Include what happened immediately before the problem: a fuel stop, a temperature warning, a loss of air pressure or another change.

Avoid clearing codes or repeatedly attempting restarts simply to see whether the warning disappears. Follow the truck manufacturer's instructions for stop-engine warnings and other critical messages. Tell the technician what you have already tried so the same steps do not have to be reconstructed during the call.

Ask what can be assessed at your location

Mobile service may be an option for diagnostics or certain repairs, but access, safety, parts and the fault itself determine what can be done. Describe the load, trailer and any site restrictions. If the truck requires recovery or a shop visit, ask how that changes the plan before authorizing work.

Confirm who can approve diagnostics and repairs, how estimates will be communicated, and how the driver will receive updates. Ask for the current availability and any estimated arrival window. Weather and other calls can change that estimate, so keep the callback line available.

Calling for help in central and southern Utah

Interstate Roadside Services offers 24/7 mobile diesel repair across Sevier, Beaver, Iron, Sanpete and Millard counties. For an I-70 breakdown near Richfield or an I-15 service request near Fillmore or Beaver, call (435) 287-8622 and give the location and symptoms first.

For work that is not urgent, use the contact form to describe the truck, requested service and location. An online message is not a confirmed emergency dispatch; call directly when the truck is broken down and you need to discuss immediate availability.